LSI Controllers can be configured using an interface called STORcli which can be dowwnloaded from the LSI website.
Sometimes when you reboot a server with an LSI controller installed it will stop at the BIOS screen displaying a message that requires user input before the machine will continue to boot.
So stop this behavior you can use the following commands.
C:\StorCli>storcli64 /c0 show bios
Controller = 0
Status = Success
Description = None
Controller Properties :
=====================
-------------------------------------------------
Ctrl_Prop Value
-------------------------------------------------
Basic Input/Output System (BIOS) ON
Auto Boot Select(ABS) OFF
BIOS Boot Mode Pause on errors
Device Exposure Expose All
-------------------------------------------------
Now issue the command "storcli64 /c0 set BIOS mode = IE"
and the following will be displayed
Controller = 0
Status = Success
Description = None
Controller Properties :
=====================
----------------
Ctrl_Prop Value
----------------
BIOS Mode IE
----------------
if you now check the status on the controller again using "storcli64 /c0 show bios"
Controller = 0
Status = Success
Description = None
Controller Properties :
=====================
-----------------------------------------------
Ctrl_Prop Value
-----------------------------------------------
Basic Input/Output System (BIOS) ON
Auto Boot Select(ABS) OFF
BIOS Boot Mode Ignore errors
Device Exposure Expose All
-----------------------------------------------
You will notice that "BIOS Boot Mode" is now set to "Ignore Errors"